Hands-Free Phone Control; Preparing The Remote Control Unit - Kenwood KIV-700 Instruction Manual

Hands-free phone control

Making a call
• Enter the dialing method selection mode: [ ]
• Select a dialing method: [ENT]
• Number dial input:
Input a digit: [0] – [9]
Input "+": [¢]
Input "#": [FM+]
Input "*": [AM–]
Clear the entered phone number: [4]
• Make a call: [DIRECT]
Receiving a call
• Answer the call: [ ]
• Switch between the private talk mode and the
hands-free talk mode: [ENT]
Call waiting
• Answer Another Incoming Call with the Current
Call Suspended: [ ]
• Answer another Incoming Call after Terminating
the Current Call: [SRC]
• Continue the Current Call: [1]
During a call
• End the call: [SRC]
Autogood products Internet store "130"

Preparing the remote control unit

Pull the battery sheet out from the remote control
unit to the direction of the arrow.
Changing the battery of the remote control
unit
Push on slide
CR2025
Pull out
(+side)
¤
CAUTION
• Do not set the remote control in hot places such
as on the dashboard.
• Lithium battery.
Danger of explosion if the battery is incorrectly
replaced.
Replace only with the same or equivalent type.
• The battery pack or batteries shall not be exposed
to excessive heat such sunshine, fire or the like.
• Keep battery out of reach of children and in
original package until ready to use. Dispose of
used batteries promptly. If swallowed contact
physician immediately.
Use a commercially available
button battery (CR2025).
Insert the battery with the +
and – poles aligned properly,
following the illustration
inside the case.
English
59
|