Removing The Blade, Blade Guard & Blade Flange - MULTIQUIP Diamond Back SP303516 Street Pro Operation And Parts Manual

Removing the Blade, Blade Guard & Blade Flange
WARNING
1. Raise the saw so that the blade will clear the ground.
2. Remove blade guard. See fig. 7
3. Remove the mounting bolt from the outer flange and bushing.
4. Remove blade, outer flange and bushing simultaneously.
5. Reinstall the flange bushing, outer flange and mounting bolt.
6. Tighten the 5/8" mounting bolt to 75 foot-pounds of torque.

The blade mounting bolt on the right side of the saw (as viewed from the
operator's position) has a left hand-thread, while the blade-mounting bolt on
the left side of the saw has a right-hand thread.
NOTE
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 21
Remain Clear of all parts of saw while installing blade to
prevent crush injury or death.
Verify the engine start switch is OFF before installing
blade.
Tighten the 5/8" blade-mounting bolt to 100-125 foot-
pounds torque.
Blade Guard
Figure 7. Blade Guard Removal
MQ SP-3035 CONCRETE SAW