Accessories And Consumables - Konica Minolta PagePro 9100 Installation Manual

Symptom
The printer is
printing codes
or not printing
at all when in
ESP mode.
Printouts
seem faded on
one side of the
page.
If you've followed all of the instructions and still have problems you can't
solve, refer to the User's Guide for more detailed instructions. For more infor-
mation on how to contact the KONICA MINOLTA office closest to you, check:
The Service & Support Guide in PDF on the Documentation CD-ROM.
This lists sources of service and support for many areas of the world.
For the most current information globally, check www.konicaminolta.net/
printer/.

Accessories and Consumables

Contact your local vendor or www.konicaminolta.net/printer/ for purchase
information, part numbers, and pricing, or go to www.q-shop.com. If you have
any questions, go to printer.konicaminolta.net/support and click on Answer
Base.
Accessories
Description
4-bin Mailbox
Crown for DECnet-TCP/IP
Interface
CrownNet for Ethernet
10BaseT/100BaseTX Interface
28
Cause
The printer emulation is
not correct.
Your ESP timeout is too
short.
The printer is not on a
level enough surface.
Equipped with 10BaseT connector
Equipped with RJ45 connector
Solution
Reconfigure the port to the specific
printer emulation of the file you are
trying to print.
If a PostScript file prints PostScript
statements while the printer is in ESP
mode, increase the ESP
timeout in the Administration/
Communications/Timeouts/ESP
Timeout menu.
Level the printer surface. It should not
exceed ±1° slant in any
direction (for example, a round pencil
laid on the surface shouldn't roll in any
direction).
Remark(s)
Accessories and Consumables