Plugging In/Turning On The Printer - Konica Minolta PagePro 9100 Installation Manual

Plugging in/Turning on the Printer

1
Make sure the printer is turned off.
2
Plug the printer power cord into the
printer and into a dedicated, grounded,
surge-protected electrical outlet.
In compliance with UL
guidelines, "The appliance
inlet is considered to be the
main disconnect device."
3
Turn on the printer.
After approximately a 70-second
warmup (assuming normal
temperature and humidity), your
printer prints a startup page and
displays "IDLE" on the message
window.
If "IDLE" is not displayed in the
message window after the printer is
turned on and warmed up, recheck the setup. If the startup page doesn't
print or the print quality is not good, skip ahead to "Troubleshooting" on
page 26.
The printer automatically switches to power-saving (energy-saving) mode
after 30 minutes of inactivity. You can change the number of minutes in the
Administration/Engine/Energy Saver menu.
Attention
Never turn the power off while the printer is receiving data or printing.
16 Plugging in/Turning on the Printer