Accessories And Consumables - Konica Minolta magicolor 2200 DeskLaser Installation Manual

Symptom Cause
Waste toner The transfer belt left release lever is
pack cannot not set correctly.
be installed.
The laser lens cover is not installed,
or was not installed correctly.
Toner The toner cartridge carousel dial is
cartridge turned clockwise.
carousel will
not turn.
Toner The toner cartridge
cartridge carousel release button was not
carousel dial pressed.
will not turn.
Toner A toner cartridge was not inserted in
cartridge that slot.
carousel slot
is empty.
Fuser oil The fuser release lever is not set in
roller cannot the correct position.
be installed.
OPC drum The transfer belt left release lever is
unit cannot not set to the OPC drum installation
be installed. position.
Pages come Media improperly aligned in tray or
out skewed. bad media.
The waste toner pack isn't properly
CHECK
installed.
WASTE
TONER
message
appears in
the message
window.
Error mes- A consumable item, such as paper
sage is dis- or toner, has run out.
played.
A unit or tray is not correctly
installed.
The media is jammed.
A problem occurred inside the
printer.

Accessories and Consumables

Refer to www.minolta-qms.com or www.q-shop.com for part numbers and pricing.
Accessories
Description
5-bin Mailbox
BuzzBox
Dual In-Line Memory Module (DIMM)
Duplex Unit
Lower Feeder Unit
Accessories and Consumables
Solution
Turn the left release lever clockwise to the 2 o'clock
position, then install the waste toner.
Reinstall the laser lens cover.
Turn the carousel dial counterclockwise.
Press and release the carousel release button, the turn
the carousel dial counterclockwise.
Press the toner release button and turn the carousel
dial until you reach the empty slot. Install the missing
toner cartridge. You do not have to load the toner in a
set sequence.
Turn the left release lever clockwise to the 12 o'clock
position, then install the fuser oil roller.
Turn the left release lever counterclockwise to the
12 o'clock position, then install the OPC drum unit.
Check media in trays.
Make sure the waste toner pack sits snugly against the
printer.
Handle the message according to the message display.
Remark(s)
Three models: For 100-, 120-, or 220-volt printers.
Via parallel connection for 100, 120, and 220 volts.
Additional memory must be a 64 MB, PC-100 Compli-
ant SDRAM DIMM.
Automatic duplexing.
Media tray included.
23