Position Menu - Eiki LC-HDT700 Owner's Manual

Picture in Picture
This function is used to project two images simultaneously
by placing a separate small sub screen within or next to the
main screen.
Use the Point ▲▼ buttons to select Picture in Picture and
then press the SELECT button to display a dialog box. You
can also display the dialog box by pressing and holding the
PIP button on the remote control for more than 3 seconds.
( In P in P, the larger picture is main picture, and the smaller
one is sub picture; in P by P, the left picture is main picture,
and the right one is sub picture.)
User setting
Show the selected mode (Off/User 1-5) and its status
(Stored /Free/ Adj .). User 1 and User 2 have stored
default values. See page 29 for details.
P in P/P by P
P in P: Provide the images of Main picture and Sub
picture at the ratio of Screen aspect in the Screen
Menu.
P by P: Provide the images of Main picture and Sub
picture at the ratio of 4:3.
Main picture / Sub picture
Input......Select an input from Input 1-3.
Source... Select an input source. The display varies
depending on the selected input.
Size......... Select the display size. Main picture can be
changed between 10 and 100%, and Sub
picture can be changed between 10 to 50% in
increments of 10%. When P by P is selected in
Mode, the projection size is fixed to 50%.
Position... Press the SELECT button at Position and the
display position setting screen appears.
Use the Point ▲▼◄► buttons to adjust the display
position of active frame indicated in white. The frame will
disappear after 10 seconds or when the SELECT button is
pressed.
Selecting the Main picture or Sub picture
During Picture in Picture mode, and being undisplayed On
Screen Menu, press the SELECT button to select Main or
Sub picture. (A red frame will be displayed on the selected
picture.)
Switching Input and Source
When selecting Main picture or Sub picture, input and
source can be set by pressing the INPUT button on the
side control or INPUT 1/2/3 button on the remote control.
Operation on the On Screen Menu is not necessary.
Picture in Picture
Selected
Mode
Note:
• When PIP is selected, screen is not
available.

Position Menu

Note:
• The Picture in Picture function is
not available depending on the
input signals and the selected input
terminals. Refer to List of Picture in
Picture for details. (p.95)
• When the input signal(s) is/are
incompatible, X mark will be displayed
for 10 seconds on the Main/Sub
picture.
Setting
Status (Stored /
Free/ Adj . ) of the
selected mode.
Active frame
(White)
Center line
display
57