Add Engine Oil And Fuel - Briggs & Stratton Elite series Owner's Manual

4. Secure handle to pressure washer using four provided
flange nuts.
5. Slowly tip pressure washer back in place and insert
multi–colored Spray tips in spaces provided in handle.
Install Oil Dipstick on Pump
To install oil dipstick:
1. Make sure unit is on a level surface.
CAUTION
You MUST remove the pump's shipping cap and install
the oil dipstick.
• Failure to do so will void the warranty and damage the
pump.
2. Remove and discard shipping cap located on pump
(Figure 2).
Figure 2 — Install Oil Dipstick onto the Pump
Remove shipping cap and
install oil dipstick here.
Pump Oil
Dipstick
3. Install oil dipstick.
3400 PSI Pressure Washer

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Connect Hose and Water Supply to
IMPORTANT: To avoid pump damage, you must
Shipping Cap
assemble the nozzle extension to the spray gun and attach
all hoses before you start the engine.
1.
7
CAUTION
instruction will void warranty.
Pump
Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 3). Pull down
on collar of quick connect, slide onto spray gun and let
go of collar. Tug on hose to be sure of a tight
connection.