Add Engine Oil And Fuel; Lubricate O-Rings - Briggs & Stratton Brute Operator's Manual

Add Engine Oil and Fuel
* Place pressure washer on a level surface.
NOTICE Any attempt to crank or start the engine before it
has been properly filled with the recommended oil will
result in equipment failure.
• Referto enginemanual f or oil andfuelfill information.
• Damage to equipment r esulting from failureto follow this
instructionwill voidwarranty.
* Refer to engine operator's manual and follow oil and
fuel recommendations and instructions.
NOTfCE Check oil often during engine break-in. Refer to
engine operator's manual for recommendations.
Lubricate O-Rings
Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or synthetic
grease) during assembly helps seat o-rings properly and
provides an improved seal. it also helps protect the o-ring
from damage by abrasion, pinching or cutting and extends
the life of the o-ring.
NOTfCE ALWAYSapply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump (A),
high pressure hose (B), spray gun (C), and nozzle
extension (D).
Lubricateall cennectiens shewn belew, feiiewing these
instru;tions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film is
all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
8 www.brutepewer.eem