Keithley 705 Instruction Manual page 31

The push button and TALK, LISTEN, and REMOTE LED's
also turn on at this time. During this time the Model 705 does
a cyclic redundancy check (CRC) of the ROM circuitry and a
digital self test of the RAM circuitry. Refer to program 8.
3. After all the front panel LED's are turned on then off, the
Model 705 displays the current software level for approxi-
mately 0.5 seconds. The following display is an example of
software revision level A5.
I
4. After the software revision level is displayed the Model 705
displays the primary address for approximately 0.5 seconds.
The following display is an example of primary address 17.
I
,
) IE 17 1
,
t
Once the preceding display is shown the Model 705 is in the
program 99 reset condition as defined by Table 2-5.
Table 2-5. Program 99 Reset Conditions
Function or
Program
CHANNEL
TIME
DATE
RESET
INTERVAL
SINGLE
CONTINUOUS
START/STOP
Program 0
Program 1
Program 2
Program 3
* When the Model
Reset Condition
All channels are open and the display is
set to*
1 4
p1 F o/
Time is not affected by program 99.
Date is not affected by program 99.
Reset is not affected by program 99.
Interval is set to 000.010.
Single scan mode is set to inactive.
Continuous scan mode is set to inactive.
Start/Stop function is set to stop.
Digital I/O outputs are set to 000, the
inputs are not affected by program 99.
Date is set to American format.
Settle time is set to 000.005 seconds.
Primary address is not affected by program
99.
Save relay set up is cleared.
Recall relay set up is cleared.
Number of poles is set to 2.
Alarm time is set to 00.00.00.
Self test is not affected by program 99.
Program 90 is performed.
Program 91 is not performed.
Program 92 is not performed.
Used to reset the Model 705.
Set to Channel 1.
Set to highest available channel.
35
is in
the slave mode
(program
92),
activating
.
program
99
has no effect.
2-20