Convertible Indoor Unit; Standard Accessories; Remove The Intake Grill; Drilling For Piping - Haier H-MRV Series Service Manual

7.3 Convertible indoor unit(14~18)

Standard accessories:

The following installation parts are furnished.
Use them as required.
Pipe connection requirement
Please refer to the specification to confirm the stop valve diameter and the permitted pipe drop and pipe length.
INSTALLATION PROCEDURE
Install the room air conditioner as follows:
PREPARING INDOOR UNIT INSTALLATION

1. REMOVE THE INTAKE GRILL

Open the intake grill and remove the
three or four or six screws.(Fig. 1)
Remark: The main unit can be wired before
the indoor unit is installed. Select
the most appropriate installation
order.
A. FLOOR CONSOLE TYPE

1. DRILLING FOR PIPING

Select piping and drain directions.(Fig.2) (Series14,18,24)
The piping and drain can be made in three directions as shown below.
(Fig.3)
Drain hose (Left side)
No.
1
2
3
4
5
6
7
When the directions are selected, drill a 7 cm dia. hole on the wall so
that the hole is tilted downward toward the outdoor for smooth water
flow. When the pipe is led out from the rear, make a hole in Fig.6, at
the position shown.
Drain hose (Right side)
>a__WcU[S^ <[c >a`V[e[a`Wc
Accessory parts
Remote controller
Battery
Wire clamp
Heat
insulation
sheathing
Screw
Screw cap
Remote
controller
bracket
(Fig. 1)
Tapping screw
Intake grill
(Fig. 2)
-71-
Qty.
1
2
4
1+1
2+2
1+1
1
Machine screw
Tapping screw
rear
right
down