Installing Brackets; Installing Indoor Unit - Haier H-MRV Series Service Manual

1. DRILLING FOR PIPING
Select piping and drain directions. (Fig.11)
(Fig. 11)
Install the drain hose at the rear; it should not be installed on the top or right side.
2. DRILLING HOLES FOR ANCHOR BOLTS AND INSTALLING THE ANCHOR BOLTS
When the directions are selected, drill 80mm and 50mm or 150mm dia. hole on the wall so that the hole is tilted
downward toward the outdoor for smooth water flow.
(Fig. 12)
With a concrete drill, drill four 12.7 mm dia. Holes.(Fig.12)
12.7mm
Insert the anchor bolts into the drilled holes, and drive the pins
completely into the anchor bolts with a hammer. (Fig. 13)

3. INSTALLING BRACKETS

Install the brackets with nuts, washers and spring washers.(Fig. 14)
(Fig. 14)
Spring washer
Special nut

4. INSTALLING INDOOR UNIT

Reset the hex bolts as shown in Fig.15.
Rear (Install the drain hose
in the direction.)
Right
CAUTION
Wall
6mm
Bracket
>a__WcU[S^ <[c >a`V[e[a`Wc
(Fig. 13)
Bracket (Left)
Bracket (Right)
For series 14,18,24
381
68 16 21 28
26.5
232
2-R2.5
26.5
-73-
26.5
2-R2.5
232
26.5
28 21 16 68
381