Redial - Toshiba TF 831 Manual

Transmit documents

Redial

If it was not possible for your fax message
to be sent, this may be due to various
reasons (please read page 113). One
reason may be that the other fax machine
is busy. In this case, it would make sense
to call your partner again at a later time.
This is done automatically by your fax; it
attempts to send the fax message again
approx. every 2 minutes.
You are able to individually set
the period between the call
redial attempts and also the
number of redial attempts (see
Manual call redial (from memory):
If the memory contains a job which you
wish to redial immediately, you can select
this job and manually select the redial
procedure (see adjacent diagram).
Manual call redial (from document
feed):
If you have established a call via the
MONITOR key, you can activate the
redial function by pressing the REDIAL/
PAUSE key.
TF 831/861 TOSHIBA
page 92).
START
15-03-97 SAT 19:56
TRANSMIT AVAILABLE
RESIDUAL MEMORY 75 %
LOAD DOCUMENT
REDIAL
PAUSE
REDIAL
[ENTER]:START
[ G ]:PREVIOUS SCREEN
[ H ]:NEXT SCREEN
after 5 seconds
SINGLE TRANSMIT
Toshiba Europa
21-03-97 19:33
FILE NBR = 008
/
REDIAL
NUMBER NOT LISTED
Manual call redial (from memory)
Standby mode
Requirement:
There must be at least one job which has
already been dialled and not transmitted.
Press the REDIAL/PAUSE key
Make your selection
for selecting the required job
The first available job is displayed.
Please refer to page 56 for details of the
job format.
Select the job which you want to
redial.
Confirm with START
The job is carried out again.
If there is no job available for the redial
facility, the machine displays the following
message:
Transmit documents
53
GB