Status Indicators - Sharp AL-2020 Operation Manual

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication
Drum replacement
required indicator
TD cartridge
replacement
required indicator
Misfeed indicator
SPF misfeed
indicator
Power save indicator is
steadily lit.
The paper tray indicator is
blinking.
"CH" is blinking in the display.
"CH" is steadily lit in the
display.
"OP" is blinking in the display.
"P" is blinking in the display.
A letter and a number appear
alternately.
A letter and a number appear
alternately.
Steadily Replacement of drum cartridge will be needed
lit soon. Prepare a new cartridge.
Blinking Drum cartridge must be replaced. Replace it with a new one.
Steadily Replacement of TD cartridge will be needed
lit soon. Prepare a new cartridge.
Blinking TD cartridge must be replaced. Replace it with a new one.
A misfeed has occurred. Remove the misfed paper
Blinking
referring to the description of "MISFEED REMOVAL".
Steadily
When the document feeder cover is open.
lit
An original misfeed has occurred in the SPF.
Blinking Remove the misfed originals referring to the
description of "D: Misfeed in the SPF (AL-2040)".
The unit is in the preheat mode. Press any key to
cancel the preheat mode.
The unit is in the auto power shut-off mode.
Press the start (
shut-off mode.
The paper tray is not pushed in correctly, or there
is no paper in the tray. Push the tray all the way
in or load paper in the tray.
The TD cartridge is not installed. Check if the
cartridge is installed.
Side cover is open. Close the side cover securely
by pressing the round projections near the side
cover open button.
This appears if it is detected that the OC cover is
open when copying is started. Completely close
the OC cover, or press the start (
Depending on the color and the density of the
original, "OP" blinking may appear even when
the OC cover is closed. In such a case, press the
start key again to make a copy.
The paper tray or multi-bypass tray is empty.
Load paper.
A misfeed has occurred in the paper tray or
multi-bypass tray. Remove the misfed paper.
The scan head locking switch is locked. Unlock
the scan head locking switch.
The unit will not function. Turn the power switch off
and then switch it on, and if there is again an error,
remove the power cord from the outlet, and contact
your authorized service representative.
Cause and remedy
) key to cancel the auto power
) key again.
Page
72
58
72
57
64
–
68
54
54
–
57
–
–
8
15, 17
64
9
–
63