Sharp AL-2020 Operation Manual page 50

Using the SPF (AL-2040)
The SPF is designed to hold up to 50 originals measuring from A5 to A4 and
weighting from 56g/m
• Before feeding originals in the document feeder tray, be sure to
• Before placing curled or wavy originals into the document feeder tray,
• If the original is placed correctly in the SPF, the SPF indicator will light
• Badly damaged originals may misfeed in the SPF. It is recommended
• Special originals such as transparency film should not be fed through
• Image loss (max. 4mm) can occur at the leading and trailing edges of
• To stop continuous copying using the SPF, press the clear key.
• Copying using one-sided to one-sided mode:
1
Make sure that no original is left on the document glass.
2
Adjust the original guides to the
size of originals.
3
Set the originals face up in the
document feeder tray.
Use the peep hole (see the illustration at
right) to check the position of the original.
There is an original top edge mark ▲ in the
peep hole. Align the top edge of the
original with this mark.
48
2
to 90g/m
remove any staples or paper clips from them.
be sure to flatten them. If not, original misfeeds may result.
up. If the original is not placed correctly, the SPF indicator will not
light. If the SPF is not closed correctly, the indicator will blink.
that such originals be copied from the document glass.
the SPF, but should be placed directly on the document glass.
the copies. Also image loss (max. 4.5mm in total) can occur along the
other edges of the copies. It can be 6mm (max.) at the trailing edge of
the second copy of two-sided copying.
Ensure that no indicator is lit among the original to copy indicators.
2
.
Original face up
Peep hole