Basic Installation; Hardware Setup - D-Link DNS-346 User Manual

D-Link DNS-346 USER'S MANUAL
Follow the instructions below to install a hard drive, connect to the network and power on the DNS-346. Open the shipping carton for the DNS-346 and carefully remove and
unwrap its contents. Follow the instructions below to set up the DNS-346. If this is the first time using the DNS-346 or if a new hard disk is installed, use the Easy Search utility
located on the Installation CD and follow the instructions for setting up, configuring and formatting the new drive.
To install DNS-346 on your local network, refer to the steps below:
1. Access the drive bays by sliding the faceplate up until it unlatches from the
device.
2. Once the faceplate is unlatched, pull it off the device, exposing the drive bays.

Basic Installation

Hardware Setup

Page 9 of 85