Table of Contents
Advertisement
KMR 1250 LPG
Prior to initial
start-up
User Instructions
Unloading procedure
Do not use a forklift truck for unloading as it could cause damage
!
to the sweeper.
The sweeper has been lashed onto a pallet to ensure that it can be transpor-
ted safely. The procedure for unpacking the sweeper is as follows:
1. Remove the wooden boards from the pallet and nail them onto the end of
the pallet (in front of the sweeper).
2. Detach the wires holding the sweeper in place at the ends of the pallet.
3. Knock away the blocks used for locking the wheels and use them for the
support of the wooden planks on the left and right.
4. Drive the sweeper off the pallet and down the ramp made from the boards.
5. The side brush has been tied to the chassis for transport. Undo the cord
holding it in place.
Pushing the sweeper
When you want to move the machine without automotive power
Open engine cover having previously disassembled seat, for which see
Chapter "Open cover"
Set free-wheeling lever to position "OFF"
Release parking brake
Move sweeper
Note:
Do not move the sweeper over comparatively long stretches or at speeds
over 10 km/h (e.g. when being towed).
After pushing the sweeper
Put parking brake on.
Set free-wheeling lever to position "ON"
Open cover
To open the cover the seat has to be removed.
Pull off spring connector 1 and pull out rod 2.
Remove driver's seat
Open cover to engine by grasping the handle grip under the driver's seat
and folding the cover up or backwards.
English
31
Advertisement
Table of Contents
