KMR 1250 LPG
Maintenance tasks
User Instructions
!
Safety information applicable to maintenance tasks
Before you begin any maintenance tasks, please read the enclosed leaflet
Safety Information No. 5.956-250.
!
Caution! Make sure engine cannot be started unintentionally.
In order to prevent the engine from being started unintentionally, proceed as
follows after you have parked the sweeper.
Pull out the ignition key.
Open the unit cover.
First of all disconnect the cable from the negative terminal (–), then dis-
connect the positive terminal (+).
Note:
When reconnecting the battery, proceed in reverse order – connect the
positive terminal (+) first of all, then the negative terminal (–).
The necessary maintenance tasks or daily inspections can be carried out with
the bonnet raised.
!
Injury hazard!
Do not open the bonnet until the motor has been switched off.
!
Burns hazard!
Take care not to touch the exhaust when you open the bonnet.
!
Injury hazard!
If you need to work under the waste container while it is in the raised
position, you must first of all secure the container to prevent it from drop-
ping down unintentionally:
Checking tyre pressures
Park the sweeper on a level surface.
Check the air pressure in each tyre and correct it where necessary.
Air pressure for front and rear tyres = 6 bar.
Checking the oil level
Park the sweeper on a level surface.
Pull out the dipstick.
Wipe the dipstick clean and re-insert it in the filler hole.
Pull out the dipstick again and check the result.
The oil level should be between the MIN and MAX marks.
If the oil level is below MIN – top up with oil.
If the oil level is above MAX – drain off the surplus.
Insert the dipstick back into the filler hole.
Filling up with oil
Pour engine oil type SAE 15 W 40 into the hole for the dipstick.
English
39