English
Typical applications
36
User Instructions
!
Caution while sweeping!
Do not sweep up packing bands, wires or similar items, otherwise the
sweeping mechanism will be damaged.
Do not sweep any burning/glowing objects.
Sweeping on dry ground
If there is a large amount of rubbish, such as several layers of leaves
remove the bulk by hand before you start with the sweeper.
For a small amount of normal dirt
on an even surface:
lower main brush
– set the lever to the middle position
on an uneven surface:
lower main brush
– set the lever to the lower position
switch on dust extraction
– set the switching mode lever to dry
for cleaning right up to the edges – lower the side brush
At regular intervals:
clean the filter,
empty the waste hopper.
Notes: If you are sweeping up fine dust, use the side brush as little as possi-
ble as it will increase the amount of dust stirred up by the sweeper. If the
side brush encounters an obstacle, it automatically swivels back inside the
outer contours of the sweeper. You should nevertheless try to avoid collisi-
ons.
While the sweeper is operating, the filter should be cleaned approx. every
15–30 minutes (depending on amount of dust).
Sweeping on damp or wet ground
Follow the same procedure as for sweeping on dry ground. In order to protect
the filter from moisture
switch off the dust extraction
– set the sweeping mode lever to wet
At regular intervals:
empty the waste hopper.
KMR 1250 LPG
(minimum brush wear).
(increased brush wear).
.
.