Automatic Safety Functions - RIKA INTEGRA II Manual

AUTOMATIC SAFETY FUNCTIONS

FOLLOWING A POWER FAILURE
In the case of a power failure, the stove returns to
the same operating mode it was in at the moment
the power failed.
•
ON-Mode (Manual mode)
If the stove was turned on in manual mode, the
stove will turn itself back on when power
resumes. The control display will read ST-21
(Start Phase) and then will display ON at the
conclusion of the 21-minute startup cycle.
•
TM-Mode (Automatic mode)
If the stove was in the TM mode (controlled by
your preset start and stop time schedule), the
stove will resume the preset schedule when
power resumes. If power resumes at a time
when the stove is schedule to be off, the stove
will remain off.
•
SB-Mode (Standby mode)
If the stove was off but set in the standby
mode, the control switches back into SB-Mode
approximately 2-seconds after the power
resumes. In this setting, the stove will not turn
itself back on.
NOTE: During a power failure, smoke can escape
from the stove. This is normal in a power outage.
If this occurs, open windows and doors to alleviate
the smoke.
OVERHEATING
If the stove overheats, an excess temperature
safety switch (Hi-Limit) will shut-off the pellet feed
and force the stove to shut down.
ATTENTION: If
maintenance/cleaning and inspection must be
performed by an authorized service technician
prior to subsequent use.
LOW OPEATING TEMPERATURE
If the stove cools down below a minimum
allowable temperature, the stove will go into
automatic shut down mode. This may be caused
by low pellet feed or an empty hopper.
Copyright © 2008 by Lucky Distributing
overheating has occurred,
AUGER MOTOR SHUT-OFF
When the hopper lid is open, the auger motor will
stop feeding pellets.
installed to protect you from potential injury should
you stick your finger or any foreign object into the
auger shaft.
The auger will only operate when the hopper
lid is closed.
12
This safety feature is