LifeGear 97620 Owner's Manual page 12

CARE, MAINTENANCE & TROUBLE SHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplugged the treadmill before
cleaning or routine maintenance.
CLEANING
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents. Be careful not get excessive moisture on the display panel as this might cause
an electrical hazard or electronics to fail.
Please keep the treadmill, specially, the console, out of direct sunlight to prevent screen
damage.
STORAGE
Store the treadmill in a clean and dry environment. Ensure the master power switch is off
and is at the off position and the power plug is un-plugged from the electrical wall outlet.
TROUBLE SHOOTING GUIDE
Problem
Treadmill will not
start.
Running belt slips.
Running belt
hesitates
When stepped
on.
Running belt is off
centered.
Potential Cause
1. Not plugged in.
2. Safety tether key not
installed.
3. House circuit breaker
tripped.
4. Treadmill circuit breaker
tripped.
Running belt not tight enough.
1. Not enough lubrication
applied onto the running
deck.
2. Running belt too tight.
Running belt tension not
even across the rear roller.
1. Put the power plug into the
electrical wall outlet.
2. Install the safety tether key.
3. Reset or have an electrician
replace the breaker in home.
4. Wait five minutes and then
press the switch back in.
Adjust running belt tension.
1. Apply silicone lubricant.
2. Adjust running belt tension.
Center the running belt.
11
Corrections