BT Cordless Headset H55 Quick Setup And User Manual page 45

• Charge the battery in the cordless headset for at
least three hours. For optimum daily performance,
return the cordless headset to the headset base
when not in use.
• You may need a new battery. Refer to the 'Battery
installation' section on page 5.
How do I connect my headset to a BT Converse 2100
or 2300 desk phone?
• Connect the desk phone cable directly into the BT
Converse headset port.
• Set the desk phone audio switch on the side of the
headset base to the E position.
• Switch the Corded Handset Connected switch
to YES.
• Press the button to go off hook.
• Press the Headset button on the BT Converse
phone. You should now hear a dial tone.
If you experience an echo, try the following:
• On a BT Converse 2300, increase the phone volume
and the headset volume and decrease the headset
microphone sensitivity.
• On a BT Converse 2100, increase the headset
volume and decrease the headset microphone
sensitivity.
I cannot dial out.
• Try all the suggestions above.
• You must use a telephone on the same line to dial
out. Once you have dialled the number, you can
press to join the call (page 20).
If you need some help, call us on 0800 218 2182* or go to bt.com/producthelp
• If other phones in your home or office are having
the same problem, the problem is in your wiring
or local service. Contact your telephone service
provider (charges may apply).
My cordless headset isn't performing normally.
• Make sure the power cord is securely plugged into
the headset base. Plug the unit into a different,
working electrical outlet not controlled by a wall
switch.
• Move the cordless headset closer to the headset
base. You might have moved out of range.
• Reset the headset. Turn the headset power off and
then turn it on again (page 19). Allow up to one
minute for the cordless headset and headset base
to reset.
• Reset the headset base. Unplug the unit's electrical
power. Wait for 15 seconds, then plug it back in.
Allow up to one minute for the cordless headset
and headset base to reset.
• Other electronic products such as TVs, radios,
computers and other DECT phones can cause
interference with your cordless headset. Try
installing your headset as far away as possible from
these types of electronic devices.
I get noise, static, or a weak signal even when I'm
near the headset base.
• If you are using your headset on a broadband line
you will need to fit an ADSL microfilter between
the phone line cord and the phone socket. You can
get BT ADSL microfilters from bt.com/shop.
Help 45