Electrolux EKG603302 User Manual page 22

22 electrolux
Gas oven burner nozzle
Warning! Before replacing the nozzles
ensure that the gas knobs are in OFF
position and disconnect the appliance
from the electrical supply.
Nozzle replacement
1. Remove the bottom plate of the oven
cavity (A)
2. Unscrew the two screws (C)which keep
the oven gas burner in place
3. Gently slide the oven gas burner off the
injector support (D) and slowly move it to
the left hand side, taking care not to
cause stress to the spark plug connec-
tion wire (E) and the thermocouple (F)
4. With a socket spanner 7 unscrew and re-
move the gas burner injector and replace
it with the required one (see chapter
" "
Technical data
5. Reassemble the burner following the
same procedure in reverse
6. Replace the gas type sticker (it is located
near the gas connection ramp) with the
one relevant to the new gas type which is
supplied with the injector kit
Adjustment of minimum level
To adjust the minimum level of the burner,
proceed as follow:
1. light the gas oven and set the maximum
temperature for about 10 minutes
2. turn the knob on the position of minimum
flame
3. remove the thermostat control knob
4. with a thin screwdriver adjust the bypass
screw positioned in the centre of the gas
tap control shaft (G)
)