Front Cover; Figure 8-6 Removing The Front Cover - Tektronix Phaser 480 Service Manual

Front cover

1.
Turn off the printer. Remove the power cord.
2. Remove the lower rear cover as explained in the previous procedure
"Lower rear cover" on page 8-3.
3. Remove the right side cover as explained in the previous procedure
"Right side cover" on page 8-5.
4.
Remove the left side cover panel as explained in the previous
procedure "Left side cover" on page 8-6.
5. Remove the two screws (M4 x 10, panhead) securing the front cover in
place.
6.
Reaching inside the right side of the front cover, disconnect the wiring
harness from the front panel.
7. Pull slightly downward to unlatch the front cover and then pull it
forward to remove it from the engine.
Mounting screws (M4 x 10)
Front cover

Figure 8-6 Removing the front cover

FRU Disassembly/Assembly
8850-30
Service Manual
8
8-7