M-P [Rv/Ch] Reverb + Chorus - Sony DPS-V55 Manual

Mono-Pair Effects
38 Reverb / Chorus (RV/CH)
In this combination effect, the Lch (ch1
or ch3) is a reverb, and the Rch (ch2 or
ch4) is a chorus. The output of each
effect is sent to both the L and R
channels.
Parameters
No. Name
– FxA(B) On/Off
1 Rev Time
2 PreDelay
3 Hi Damp
4 Rev BAL Direct, 99:1 ~ 1:99, Effect
5 Rate
6 Depth
7 Chr PreDly
8 Chr BAL Direct, 99:1 ~ 1:99, Effect
CH1
Reverb
(CH3)
Chorus
CH2
(CH4)
Range Comments
On, Off Turns the effect on or off.
0.3 ~ 50 s Determines how long the reverberation will last.
0 ~ 150 ms Sets the length of time between the input of the sound to be reverberated and the
output of the reverberation. Normally, set the predelay relative to the reverb length
(i.e., Set a long Rev Time, and a long PreDelay to create a greater sense of space).
0 ~ 100 Sets the ratio of high frequency reverb time in relation to the overall reverberation.
Smaller values increase the rate of attenuation in the high frequencies.
Determines the balance between the source (direct) sound to the reverb (effect)
sound. Increasing the parameter value increases the sound of the reverb.
0 ~ 100 Sets the rate (frequency or modulation speed) of the chorus low frequency oscillator
(LFO). The modulation cycles become faster as you increase this value.
0 ~ 100 Sets the depth of the chorus low frequency oscillator (LFO). The sense of modulation
becomes stronger as you increase this value. There is no chorus effect at 0%.
0 ~ 500 ms Determines how long it will take to output the chorus effect once the direct sound has
been output.
Determines the balance between the source (direct) sound to the chorus (effect)
sound. Increasing the parameter value increases the sound of the chorus.
Reverb Balance
Chorus Balance
CH1
(CH3)
CH2
(CH4)
41