Stereo Phaser - Sony DPS-V55 Manual

2 Channel Effects
21 Stereo Phaser (StPHS)
This is a standard stereo phaser. The
phaser effect adds out of phase sound
to the source to create a sort of
undulating expansion. Use the Cross
Mix to produce a more 3-dimensional
effect. Increasing the Resonance value
adds bite.
(CH3)
(CH4)
Parameters
No. Name
– FxA(B) On/Off
1 Rate
2 Depth
3 Manual
4 Resonance
5 Cross Mix
6 Spread
7 Direct Level
8 Effect Level
CH1
Phaser
Phaser
Phaser
Phaser
CH2
Range Comments
On, Off Turns the effect on or off.
0 ~ 100 Sets the rate (frequency or modulation speed) of the low frequency oscillator (LFO).
The modulation cycles become faster as you increase this value.
0 ~ 100 Sets the depth of the low frequency oscillator (LFO). The sense of modulation
becomes stronger as you increase this value. There is no phasing at 0%.
0 ~ 100 Determines which frequency the phasing will center on.
–99 ~ +99 Sets the amount of resonance. Increasing this value produces more distinct phasing
in the mid and high bands.
0 ~ 100 Sets the mix level of the cross phasers.
0 ~ 20 Determines the amount of expansion between the two channels. There is no effect
when set to "0".
0 ~ 100 Determines the level of the direct sound.
0 ~ 100 Determines the level of the effect sound.
Direct
Effect
Cross Mix
Effect
Direct
CH1
(CH3)
CH2
(CH4)
25