Callback Center (Modem) Setup Screen; Figure 59 - Callback Center (Modem) Setup Screen - ADEMCO AHDR4 User Manual

Digital Video Recorder

Callback Center (Modem) Setup Screen

Figure 59 — Callback Center (Modem) Setup screen.
NOTE: Callback Center (Modem) is not available on the E Series DVRs
If you have a modem connected to the DVR, it can be set up to dial a pager with a numeric
message when an event occurs.
NOTE: The DVR will wait for at least one minute between pages. If another event occurs
less than one minute after the DVR has notified a pager, it will not dial the pager. It does
this so that the telephone line will not be tied up.
Highlight the box beside Pager Number and enter the telephone number of the pager. Enter
the number as it must be dialed from your telephone system; e.g., if you must dial "9" for an
outside line, enter "9" before the pager number.
Highlight the box beside Mailbox and enter the voice mailbox number if your pager uses a
voice mailbox.
Highlight the box beside Site ID and enter a three-digit site ID number.
When an event occurs, the DVR will dial the pager and leave a four-digit number. The first
three digits are the site ID number and the last digit is the type of event. For example, "0753"
means that Site 75 has lost video.
You can save your changes by highlighting OK and pressing the button . Selecting Cancel
exits the screen without saving the changes.
51