Password Setup Screen; Figure 60 - Password Setup Screen - ADEMCO AHDR4 User Manual

User' s Manual

Password Setup Screen

An Administrator password is required to turn the system off, enter the setup screen, load
default setups, clear all data, change system date and time and change the Administrator
password. Highlight Password in the Main menu and press to enter the Password screen.
Figure 60 — Password setup screen.
Highlight the box beside User and press the button to toggle between On and Off. If the
password is set to On, you will be asked to enter the current password so that you can turn it Off.
If the password is set to Off, you will be asked to enter the new password and to confirm it
before it will be turned on.
The Administrator password cannot be turned On and Off. You can change the Administrator
password by first entering the current password, entering a new password and finally
confirming the new password.
To change the password, highlight the Password box and press the
button. A window
appears asking you to enter the current password. If you enter the correct password, another
window appears asking you to enter a new password using the camera buttons. After you press
the button, another screen appears asking you to confirm the new password.
NOTE: The Admin and User passwords are composed of up to eight digits using the
camera buttons. The default Admin password is: 4321.
CAUTION: Write down the new password and save it in a secure place. If the
password is forgotten, the unit must be reset using the Factory Reset Button
and all data settings will be lost.
52