Figure 29 - System Check Screen - ADEMCO AHDR4 User Manual

Digital Video Recorder
Figure 29 — System Check screen.
Highlight the box under the On/Off heading and press the button. This toggles between On
and Off. When it is On, the DVR reports a fault condition if it does not detect any recording or
if there is an alarm during the designated time.
Highlight the box under the Interval heading and press the
button. A slide bar appears
allowing you to set the check interval from 1 Hour to 30 Days by using the Left and Right arrow
buttons.
The Status field displays the fault conditions. When it is Good, there was recording or an
alarm occurred during the designated time. When it is Bad, there was no recording or no alarm
occurred during the designated time.
23