Adjustments And Settings - Ariston Type C Installation, Servicing And Operating Instructions

17. Adjustments and settings

The boiler is delivered with pre-set values described
in menus 3 and 4.
All settings must only be changed by the installer or
a qualified person. To gain access to the setting
buttons please, open the front control panel cover
P. (Fig. 42) and follow the instructions below.
Fig. 43
DISPLAY
Pressing the, comfort, reset, menu, +, -, or setting buttons will make the display light. The light will go out 30 seconds after the
last button has been pressed.
To gain access to the setting menus press the
the 1st digit.
Changing the menu :
Press the Menu button
to the next Section.
Setting a parameter in a section :
Press the or
Note : When you arrive at the last section of a menu, pressing the
are at the first section, pressing the
Changing section in a menu (available only for menu 3 and 4)
Press the setting button
button to select the correct value then press the setting button to select this modification and to exit the setting mode. The
3rd and 4th digit stop flashing.
Recalling the basic configuration :
Select menu 3 or 4 then press the
to indicate that the operation is completed.
Clearing Menu 1 (default register) :
Select menu 1 then press the
indicate that the operation is completed.
Note : To exit from setting mode, leave the boiler for approx. 1 minute, the display will switch back to user mode.
36
On/Off push button Comfort button Reset push button
- button
Menu button
2nd digit
1st digit
and
(Fig. 43). The menu number is displayed for 3 seconds. Press the menu button again to change
button to change from between sections.
button will change to the last section of the menu.
to enter the modification mode, The 3rd and 4th digits will be flashing, press the
buttons together for more than 5 seconds. The digits will flash CM for a while
and
and buttons together for more than 5 seconds. The digits will flash CM for a while to
+ button Setting button
buttons together for 5 seconds. (Fig. 43). Menu 1 is displayed on
button will change to the the 1st section. When you
:
Fig. 42
P
3rd digit
4th digit
or