Settings - Adjustment - Problem Identification Menus; Accessing The Menus - Ariston CLAS HE Series Installation And Servicing Instruction

Accessing the settings - adjustment - problem identification
menus
The boiler can be used to manage the heating and domestic hot
water production system in its entirety.
Navigation within the menus enables the boiler system +
connected peripheral units to be customised, optimising
operation for maximum comfort and maximum saving. It also
provides important information relating to the efficient operation
of the boiler.
The following menus are available:
2 Boiler Parameter
 1 Service code (accesso riservato tecnico qualificato)
  General setting
 3 C.H. Parameters - Part 1
 4 C.H. Parameters - Part 1
 5 Domestic Hot Water
 9 Menù  Reset to factory setting
3 Solar & Storage
3 0 General setting
3 1 Service code (accesso riservato tecnico qualificato)
3  Special setting
4 Zone 1 Parameters
4 0 Set-point Zone1
4 1 Service code (accesso riservato tecnico qualificato)
4  Zone 1 Setting
4 3 Diagnostics
4 4 Zone device mangement
5 Zone 2 Parameters
5 0 Set-point Zone
5 1 Service code (accesso riservato tecnico qualificato)
5  Zone  Setting
5 3 Diagnostics
5 4 Zone device mangement
5 5 Multizone
7 Test & Utilities
8 Service Parameter
8 1 Service code (accesso riservato tecnico qualificato)
8  Boiler
8 3 Boiler Temperature
8 4 Solar & Storage
8 5 Service
8 6 Statistics
8 7 E@sy - NOT ACTIVE
8 8 Error History

settings - adjustment - problem identification menus

The parameters relating to each individual menu are listed in the
following pages.
The various parameters can be accessed and modified using th
m /O button and
enu k
below).
p
rogrammatioN
button
To access the Menus, open the cover and proceed as follows:
1. Press the m
display.
. Press the
"200
3. Press the m
flash, e.g. "210.
Caution! The menus reserved for qualified technicians may only be
accessed after setting the access code.
4. Press the m
5. Press the
6. Press the m
figures will flash, e.g. "220".
7. Press the
"230
8. Press the m
three figures will flash, for example: "230".
9. Press the
"231
10. Press the m
indicate the value, e.g "70".
Note: The parameter value will be displayed for 0 seconds, then
will begin to flash in alternation with the parameter, e.g.
231.
11. Press the
1. Press m
enu
saving.
To exit, press the e
restored.
For menus which do not require the access code, it is possible to pass
directly from the menu to the sub menu.
programmation buttons
Menu/Ok-
button
/O button; the first figure
enu k
buttons or
to select a menu, for example:
/O button; the second figures on the display will
enu k
/O button; 222 will appear on the display unit.
enu k
buttons or
to select code 234
/O button to select the sub menu; the second
enu k
buttons or
to select a sub menu; for example:
/O button to access the sub menu parameters; the
enu k
buttons or
to select a parameter; for example:
/O button to access the parameter; the display will
enu k
buttons or
to select the new value, e.g. "75".
/O to save the change or press e
k
button until the normal display screen is
sC
and .
(see fig.
will flash on the
000
"70 >
to exit without
sC
33