Safety Features; Fahrenheit To Celsius; Cleaning And Storage - Honeywell HZ-960 Series Instructions Manual

OPERATION (continued)
• The MyTemp Settings (
settings and the timer function.
- To set a MyTemp preference, choose any heater setting (heat and/or
timer) and hold a MyTemp button for 3 seconds (Fig. 5), until it beeps.
The MyTemp Button will flash then illuminate and your favorite setting
is stored. It can be re-set at any time.
NOTE: Both MyTemp Settings will default to Constant High (L3) at first
operation until you choose your favorite setting.
- To exit from a MyTemp Setting, simply press any Thermostat Control
Button ( ) to choose another setting.
• To select a pre-set MyTemp Setting – simply press the MyTemp Button and the heater will run in that favorite mode.
• To shut the heater off, press the Power Button ( ) and the heater will begin Powering Down as displayed in Status by a
blinking light. The heater will automatically shut off in about 60 seconds after the fan cools the internal components.

SAFETY FEATURES

The Honeywell Infrared Heater is equipped with several devices and features for added protection:
• Cool to touch housing and handle.
• A four way tip-over switch that disables the heater if it is accidentally tipped in any front, back or side to side directions.
• A high temperature safety control prevents overheating. See troubleshooting section.
• Equipped with an overheat switch that will shut down the unit.
• This heater was created using a high quality safety plastic.

FAHRENHEIT TO CELSIUS

• Press and hold both Thermostat Control Buttons (
NOTE: The Remote will not change between Fahrenheit and Celsius - only the controls on the heater.

CLEANING AND STORAGE

• Periodic cleaning of the filter is recommended. Turn the heater Off ( ) and unplug it. Allow it to cool. Remove the Filter Cover and
clean/vacuum the Filter.
• It is recommended that the Infrared Heater be cleaned at least once a
month and before off-season storage.
• Turn the heater Off ( ) and unplug it. Allow it to cool.
• Use a dry cloth only to clean the external surfaces of the heater.
DO NOT USE WATER, WAXES, POLISHES OR ANY CHEMICAL SOLUTION.
• Clean the Infrared Heater using the above-mentioned steps.
Wrap the cord around the unit. Place in its original box and store
it in a cool, dry place.
• This heater does not disassemble.
6
) allow you to pre-set two favorite heat
) for three seconds to change between Fahrenheit and Celsius and back.
Fig. 5
Fig. 6
Filter
Filter Cover