Safety Features; Fahrenheit To Celsius - Honeywell HCE300 Series Manual

SAFEGUARD™ MOTION SENSOR SAFETY FEATURE (HCE323/HCE353 Series only)
The Honeywell Safeguard™ Motion Sensor Digital Tower (Model series HCE323/HCE353 only) is equipped with an additional
safety feature. If an object is placed too close to the heater, the Motion Sensor Light (Fig. 2) will blink to warn you that there is an
obstruction. If the object is not removed, the sensor will disable the heater, turning the heater off until the object is removed. The
heater will restart after a few seconds once the object is removed.
• Press the Safeguard™ Motion Sensor Button (
Fig. 2
Safeguard™ Motion Sensor Light
REMOTE CONTROL (HCE323/HCE353 Series only)
The Honeywell Safeguard™ Motion Sensor Ceramic Digital Tower Heaters can be completely controlled with the remote. This
remote uses a button cell type battery which comes included in the remote.
• To activate the battery, simply pull the plastic tab.
• Place remote control in the holder in the back of the heater when not in use.

SAFETY FEATURES

The Honeywell Ceramic Tower Heater is equipped with several devices and features for added protection:
• A 360° tip-over switch that disables the heater if it is tipped in any direction.
• A high temperature safety sensor prevents overheating.
• This heater is also equipped with a thermal cut-off fuse that will permanently shut down the heater should it operate at
a higher than normal temperature.
• This heater was built using a high temperature plastic and has a cool to touch housing and handle.
• This heater is designed with thermal insulated wiring for heat resistance and reinforced wire connections to help protect against
loose connections.
• HCE323/HCE353 Series only also has a Safeguard™ Motion Sensor that shuts the heater off if an object gets too close to the
motion sensor.

FAHRENHEIT TO CELSIUS

• Press and hold both Thermostat Control Buttons (
NOTE: The Remote will not change between Fahrenheit and Celsius - only the controls on the heater.
4
) (Fig. 3) to turn on or off this feature.
Fig. 3
) for three seconds to change between Fahrenheit and Celsius.
Safeguard™ Motion Sensor Button