Safety Features; Troubleshooting - Honeywell HCE870 Series Owner's Manual

SAFETY FEATURES

The ThermaWave™ 6 Heater is equipped with several devices and features for added protection:
• A 360º tip-over switch that disables the heater if it is tipped in any direction.
• Two high temperature safety sensors prevents overheating. If activated, unplug the device and wait at least
20 minutes or allow the unit to cool completely. Make sure the operating conditions are safe and then plug
the heater back in and follow the OPERATION instructions.
• Thermal insulated wiring for heat resistance and reinforced wire connections to help protect against loose
connections.
• Built using a high temperature plastic and has a cool to touch housing and handle.
• The 8 hour timer auto off is the default setting upon powering the unit on. To select another option, press timer.
CLEANING
We recommend that the ThermaWave™ 6 Heater be cleaned at least once a month and before
off-season storage.
• Turn the heater OFF ( ) and unplug it. Allow it to cool.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES,
POLISHES OR ANY CHEMICAL SOLUTIONS.
STORAGE
• Before storing, clean the ThermaWave™ 6 Heater using the above-mentioned steps. Wrap the cord around
the unit. Place in its original box and store it in a cool, dry place.

TROUBLESHOOTING

If your ThermaWave™ 6 Heater shuts off unexpectedly or fails to operate, one of your heater safety features
may have been activated to prevent overheating.
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstructions. If you find an obstruction, turn the heater OFF and unplug it. Allow the heater
to cool completely, then remove the obstruction. Wait at least 20 minutes, then plug the heater back in
and follow the OPERATION instructions.
• Make sure the heater is on a flat level surface so that the tip over switch is not engaged.
6