ThinkPad X100e Hardware Maintenance Manual page 89

• "1100 CRT board assembly (with cable)" on page 72
• "1110 Speaker assembly" on page 73
• "1120 I/O board (for ThinkPad X120e)" on page 74
• "1130 System board, fan assembly, and backup battery" on page 75
Table 25. Removal steps of DC-in cable and base cover assembly
Note: Applying labels to the base cover
For ThinkPad X100e
The new base cover FRU is shipped with a kit containing labels of several kinds. When you replace the
base cover, you need to apply the following labels:
2
Homologation label
3
FFC label
5
Certified label under battery
6
Serial number barcode blank label
9
Information label under door
10
SIM information label under door
Following labels need to be peeled off from the old base cover, and need to be put on the new base cover.
1
Windows license label (COA) (only for Windows 7 models)
4
Ethernet label
7
Wireless WAN label
8
China Wireless WAN label
For some models, you also need to apply one or two FCC labels. Check the old base cover; if it has one or
two FCC labels, find duplicates of them in the label kit and apply them to the new base cover.
For the location of each label, refer the following figure:
1
2
3
.
Chapter 8 Removing and replacing a FRU
83