Table 16. Removal steps of keyboard (continued)
Table 17. Installation steps of keyboard
When installing the keyboard, do as follows:
1. Attach the keyboard connectors.
2. Attach the keyboard so that the front edge of the keyboard are under the frame as shown in this figure.
3. Secure the keyboard by tightening the screws from the bottom side of the computer.
1090 Palm rest assembly, power-on board assembly (with cable), and
microphone
For access, remove these FRUs in order:
6
4
5
7
8
7
.
Chapter 8
Removing and replacing a FRU
67