Remote Control Overview; Operation Considerations; Menu Navigation; Main Menu - JBL Performance AV1 User Manual

Basic Operation

REMOTE CONTROL OVERVIEW

The AV1 remote control provides full operation of the AV1, including
commands such as menu navigation that are not available from the
front-panel. The command matrix that beginning on page 2-10 indi-
cates the commands remote control buttons perform when each
command bank is active. The numbered items in the matrix corre-
spond with the remote control illustrations on pages 2-10 to 2-13.

OPERATION CONSIDERATIONS

The following factors can improve or impede remote control
operation.
Note the following before operating the AV1 remote control:
• The remote control must be in line-of-sight with the front-
panel IR receiver. Eliminate obstructions between the remote
control and the IR receiver. The remote control may become
unreliable if strong sunlight or fluorescent light shines on the IR
receiver.
• For optimal performance, position the remote control at a 30
degree angle no more than 17 feet (5m) from the AV1. Placing
the AV1 inside a smoked glass cabinet will reduce the remote
control range.
• Remote controllers for different components can interfere with
one another. Avoid using remote controls for different compo-
nents at the same time.
• Remote control batteries should be replaced as needed. See
page 1-5 for battery installation instructions.
2-6

MENU NAVIGATION

Use the remote control Menu arrows to navigate the extensive
menu structure shown in the Appendix (A-5 to A-13). The table on
the previous page indicates the navigation functions remote con-
trol Menu arrows perform.

MAIN MENU

The MAIN MENU, shown to the right, repre-
sents the beginning of the menu structure.
Use the MAIN MENU to open the three main
menu branches: MODE ADJUST, AUDIO
CONTROLS, and SETUP. See Sections 3, 4,
and 5 for information about these menu branches.
JBL Performance

MAIN MENU

MODE ADJUST
AUDIO CONTROLS
SETUP