Table of Contents
Advertisement
get down to the cable within the scooter. Pull it through the body and then through
the handle bar down tube.
3.) Unscrew the two screws on the electric start section of the throttle. This piece
should split to allow you to remove the throttle cable from the handle. Release the
throttle cable from the handle.
4.) Unscrew the metal "L" piece that goes into the electric start.
5.) Screw the new throttle's "L" joint into the old electric start.
6.) Attach the cable to the old throttle handle.
7.) Replace the top portion of the split electric start plastic piece and tighten down onto
handle bar.
8.) Thread cable through the handlebar down tube and through the scooter.
9.) Reconnect it to the throttle on the carburetor. Make sure the throttle cable end
settles down into the groove on the throttle on the carb.
10.) Replace air filter cover and deck plate.
How To Install Fuel Lines
1.) Attach the larger diameter hose on the nipple that is straight.
2.) Attach the smaller diameter hose on the nipple that is bent at a 90 degree angle. It
also has the fuel filter attached.
3.) Squeeze the arms together on the retaining clip to increase the diameter and slide it
over the hose.
How To Install Ignition Coil
1.) Unplug spark plug from wire.
2.) Remove air breather assembly.
3.) Remove plastic covering motor and exhaust.
4.) At this point you can see the ignition coil. Remove the two bolts holding coil in
place.
5.) Reinstall new coil using a business card between the fly wheel and the coil as a
spacer. Tighten bolts with card in place, when bolts are tight then you can remove
the business card. Your coil should be gapped correctly.
6.) Reinstall the plastic motor covers and your scoot should have spark.
How To Install Engager
1.) Stick a screwdriver in the fin's on the right side of pull starter to hold the motor from
turning over.
2.) Take off net in center of engager.
3.) Unscrew and remove.
Page20
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
