How To Install Bearings; How To Remove & Insert Pin Connectors; How To Determine Which Controller Version You Have; How To Replace/Install Controller - X-TREME X-600 Owner's Manual

How To Install Bearings

1) Remove the front/rear wheel.
2) Remove the old bearing. To do this, you will need to insert something, like a screw driver,
from the opposite side and simply push it out.
3) Put the new bearings in. You will want to use something like a rubber mallet so you do not
crack the bearings. Set the wheel on a flat, absorbent surface, like a work bench. Tap the
bearing into the wheel evenly.
4) Re-install the tire and test ride.
How To Remove & Insert Pins In Connectors
1) Look down inside the connector; you will see a metal pin. The pin is held in place by a
small tab that bends outward.
2) Reach inside the front of the connector with a dental pick or jewelers screwdriver and
bend the tab in then pull the metal pin out the back of the connector.
3) Reinsert the new wires into the white connectors.
How To Determine Which Version Controller You Have
Version 1 – All 8 white connectors Version 2 – 6 White & 2 Black Connectors
Part #X600-220-1 Part #X600-220-2
How To Replace/Install A Controller
1) Remove Main Fuse.
2) Gain access to where the Controller is located.
3) Place the New Controller alongside the Original Controller.
4) Disconnect and re-connect One (1) Connector at a time. We recommend starting with the
Page19