Safety Summary - Mcube BioCon-500 User Manual

User's Manual for BioCon-500

Safety Summary

1. Since the surface of the Probe affects the result of data, users should
keep as follows;
(1) Clean the cap of probe with tissue before using the device.
(2) Apply gel on the top of probe, position the probe on the abdomen of
(3) Try to scan at least 2 ~ 3 times to get more accurate results.
(4) Remove and re-apply gel after scanning 4 ~ 5 times, to scan again.
(5) Remove the residual gel on the probe's surface after scanning finished.
(6) Move carefully not to drop the probe off.
2. The device can be used as being charged. In case of using the device
as being charged, users should assure if the device is connected to
the charger.
3. The device should be made its adapter parted from the main unit with
the charging lamp(Yellow) off.
4. The indication lamps (Green, Yellow) are turned off automatically in
SCAN mode and turned on as the SCAN mode is terminated, which
users should not be misconceived for an equipment failure.
5. In case the error message appears, users can refer to the operation
manual and take a proper action. [p. 30, 3.9 Error Message]
6. The device should be used after ultrasonic gel applied on the probe or
patient's abdomen. Thus, users should avoid using this device against
patients with skin disease or injury.
7. In order to get more accurate data, the probe should be positioned
toward patient's bladder during examination.
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
patient, and start scanning.
TM
1/41