Others - Panasonic DMR-BW880 Operating Instructions Manual

Changing the unit's settings

Others

Others
Standby Settings
Remote Control
Clock
Setup
PIN Entry
System Update
System Information
DivX Registration
Initialize
Others
∫ Standby Settings
Others
Standby Settings
Standby Settings
Power Save in Standby
Automatic Standby
Automatic Standby after OTR
Automatic Standby after Copy
Power Save in Standby
On It will go into the "Power Save in
Standby" mode.
On Timer "Power Save in Standby" is activated
when the set time comes.
≥If the clock has not been set, "Power
Save in Standby" is activated at all
hours.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
≥This function cannot be enabled when the DLNA
function is enabled in "Home Network ( DLNA )
Settings". ( 67)
Automatic Standby
Set the time to turn the unit to standby mode
automatically.
After the unit has finished operating, the unit will be
turned to standby mode once the set time has passed.
Automatic Standby after OTR
If "On" is selected, this unit is turned to standby mode
when it is not operated for approximately 5 minutes
after completing "Automatic Stop" or "Recording Time"
( 24).
Automatic Standby after Copy
If "On" is selected, this unit is turned to standby mode
when it is not operated for approximately 5 minutes
after completing copy (
82
VQT2X37
Access Enlgish
BD 1
Access Enlgish
Enlgish
On
4 hours
On
Off
44).
∫ Remote Control
Change the remote control code on the main unit and the
remote control if you place other Panasonic products close
together.
≥Use "BD 1", the factory set code, under normal
circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the number button
([1] to [6]) for more than 5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
≥Operation is possible only with Panasonic remote controls
with "IR6" printed at the bottom when the remote control
code of this unit is set to "BD 4", "BD 5" or "BD 6".
BLU-RAY DISC RECORDER
BLU-RAY DISC RECORDER
IR6
∫ Clock
If the time is not set correctly, use the settings listed in the
method below.
Clock
Automatic
On
Time Date
0 00 10
2010 / 1 /
Please set the clock.
OK: access RETURN: leave
≥Automatic
This unit usually obtains time and date information from
digital broadcasts.
But, if the time is not set correctly, set it to "Off" and
perform "Manual setting".
≥Manual setting
1 Select "Off" of "Automatic", then press [OK].
2 Select the item you want to change.
3 Change the setting.
4 Press [OK] when you have finished the settings.
∫ PIN Entry
You can set/change the PIN. (
IR6
IR6
1
74)