Software (Firmware) Update - Panasonic DMR-BW880 Operating Instructions Manual

Software (Firmware) Update

Blu-ray Disc technology and broadcast services continue to
add new features. As they evolve, software (firmware)
updates may be required to support the latest features.
Panasonic strives to continually update software (firmware)
as new technology is released. It's very important you install
the latest updates to maintain proper operation of your unit
using one of the following methods.
For the latest software (firmware) update information, please
refer to the Panasonic support site below.
http://panasonic.jp/support/global/cs/
Internet connection
If your unit is connected to the Internet connection, software
of this unit can be updated automatically from the Internet at
the specified time.
(Default setting is 3 a.m.
≥Network connection and setting are required. (
≥It takes about 1 hour to update.
∫ If a software (firmware) update is
available, a notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
≥Update of the software (firmware) will start when the
unit is turned to standby mode.
≥ The download time depends on the network environment.
≥ If the timer recording is scheduled within 1 hour at the start of the
download, the download will not be executed.
≥ If you do not want to perform the software (firmware) update, set the
"Software Update in Standby" to "Off". (
Using a CD-R disc
If your unit is not connected to the Internet connection, you
can download the latest firmware version from the
Panasonic support site. After you copy the latest firmware to
a CD-R disc, play the disc in the unit and it will automatically
update the firmware.
84
VQT2X37
83, Software Update in Standby)
13, 19)
83)
∫ The unit's display during the update
≥When "FINISH" is displayed, update of the software
(firmware) has completed.
You cannot operate the unit until the update is
complete. Removing the AC mains lead while the
update is in progress may damage the unit. Don't
remove the AC mains lead during the update.