Speed Motor Assembly - Version 2; To Replace The Speed Motor Assembly - Life Fitness X5i Service Manual

Life Fitness Models X5i, X5, X3i, and X3 Cross-Trainers
How To... Replace the Speed Motor Assembly - Version 2
Special Service Tools Required: NONE
1. Remove the Side Shrouds. See "How To..." in
this section.
2. Disconnect the Brake Cable from the Magnetic
Brake, and then from the Speed Motor.
3. Remove the mounting Bolts and Nuts from the
Speed Motor.
4. Disconnect the wire harness.
5. Install new Speed Motor in reverse order.
6. Apply power to unit, which will automatically set
unit level at 1.
7. Using the cable adjuster, set the mark on the
slide block so that it is positioned between the
two marks on the magnetic brake.
8. Using Diagnostic State 4, run resistance to
maximum level, and then back down to level #1.
If no motor error message appears, the unit is
set properly. If motor error message appears,
then repeat Step 7.
Magnetic
Brake Assy
Slide
Block
Mark
Cable
17
Bolts
Speed Motor
Nuts
Brake
Cable
Clip
Brake
Marks
Slide
Block