The Router's Front Panel - NETGEAR RangeMax WPN824 Reference Manual

The Router's Front Panel

The front panel of the WPN824 router contains the status lights described below.
Figure 2-1
You can use the status lights to verify connections. Viewed from left to right, the table below
describes the lights on the front panel of the router.
Table 2-1. Status Light Descriptions
Item Function Activity
1 Power On Green Solid
Off
2 Test On
Off
Slow blinking
3 Wireless On
Off
Blink
4 Internet Amber off
Amber on
Amber blinking
Green off
On
Blink
5 LAN Green
Amber
Introduction
Reference Manual for the RangeMax Wireless Router WPN824
Description
Power is supplied to the router.
Power is not supplied to the router.
The unit is performing the power-on self-test diagnostic.
The unit successfully completed the power-on self-test diagnostic.
Reset button is being pushed, restoring the factory default settings.
The wireless interface is enabled.
The wireless interface is turned off.
Data is being communicated over the wireless network.
No Ethernet cable is connected to the modem.
Ethernet cable connection to modem is good.
Packets are being transmitted and received from a modem or other
network device, but no IP address has been received.
No IP address received.
IP address received.
IP address received and data is being transmitted and received.
The LAN port has detected a 100 Mbps link with an attached device.
The LAN port has detected a 10 Mbps link with an attached device.
v1.0, November 2005
2-7