Troubleshooting; Basic Functioning; Power Light Not On - NETGEAR RangeMax WPN824 Reference Manual

Hide thumbs Also See for RangeMax WPN824:

Reference manual (174 pages)

Setup manual (38 pages)

Product data (2 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

Table of Contents

This chapter gives information about troubleshooting your RangeMax Wireless Router WPN824.

After each problem description, instructions are provided to help you diagnose and solve the

problem.

Basic Functioning

After you turn on power to the router, the following sequence of events should occur:

1. When power is first applied, verify that the Power light

2. After approximately 10 seconds, verify that:

a. The power light is solid green.

b. The LAN port lights are lit for any local ports that are connected.

c. The Internet port light is lit.

d. A port light is lit, to indicate a link has been established to the connected device. If a LAN

port is connected to a 100 Mbps device, verify that the port's light is green. If the port is

connected to a 10 Mbps device, the light will be amber.

If any of the above conditions does not occur, see the appropriate following section.

Power Light Not On

If the Power and other lights are off when your router is turned on:

•

Make sure that the power cord is properly connected to your router and that the power supply

adapter is properly connected to a functioning power outlet.

•

Check that you are using the 12V DC 1A power adapter NETGEAR supplies for this product.

If the error persists, you have a hardware problem and should contact technical support.