Lights Never Turn Off; Lan Or Wan Port Lights Not On - NETGEAR RangeMax WPN824 Reference Manual

Reference Manual for the RangeMax Wireless Router WPN824

Lights Never Turn Off

When the router is turned on, the lights turns on for about 10 seconds and then turn off. If all the
lights stay on, there is a fault within the router.
If all lights are still on one minute after power up:
• Cycle the power to see if the router recovers.
• Clear the router's configuration to factory defaults. This will set the router's IP address to
192.168.1.1. This procedure is explained in
Password" on page
If the error persists, you might have a hardware problem and should contact technical support.

LAN or WAN Port Lights Not On

If either the LAN lights or Internet light are not lit when the Ethernet connection is made, check
the following:
• Make sure that the Ethernet cable connections are secure at the router and at the hub or
workstation.
• Make sure that power is turned on to the connected hub or workstation.
• Be sure you are using the correct cable:
— When connecting the router's Internet port to a cable or DSL modem, use the cable that
was supplied with the cable or DSL modem. This cable could be a standard straight-
through Ethernet cable or an Ethernet crossover cable.
7-2
7-7.
v1.0, November 2005
"Restoring the Default Configuration and
Troubleshooting