Table of Contents
Advertisement
7.5 Log Settings
If you have a Syslog Server on your LAN, this screen allows you to configure the
Access Point to send log data to your Syslog Server.
Data - Syslog Settings Screen
Syslog Server
Server Name/IP Ad-
dress
Minimum Severity
Level
Email Alerts
Email Alerts
Log Queue Length
Figure 2: Syslog Settings Screen
Select the desired Option:
•
Disable - Syslog server is not used.
•
Broadcast - Syslog data is broadcast. Use this
option if different PCs act as the Syslog server at
different times.
•
Unicast - Select this if the same PC is always used
as the Syslog server. If selected, you must enter the
server address in the field provided.
Enter the name or IP address of your Syslog Server.
Select the desired severity level. Events with a severtiy
level equal to or higher (i.e. lower number) than the
selected level will be logged.
If enabled, an e-mail will be sent. If enabled, the e-mail
address information (below) must be provided.
Enter the desired length of the log queue. The default is
20 entries.
45
Advertisement
Table of Contents
