Residual Heat Indicator; Switching On The Dual Cooking Zone - Baumatic BHC635SS Instruction Manual

60cm touch control ceramic hob
Table of Contents

Advertisement

Residual heat indicator

o After a zone is switched off, the corresponding
o When the temperature of the zone falls below 60°C, then the
letter "H" will go out.
o IMPORTANT: The residual heat indicator will disappear if the
mains supply to the product is cut.
o IT IS STILL POSSIBLE TO BURN YOURSELF ON A HOB
ZONE,
EVEN
DROPPED BELOW 60°C.

Switching on the dual cooking zone

The dual cooking zone has two cooking areas that you can use; a
central section and an outer section. You can use the central section
(A) independently or both sections (B) at once.
o Adjust the zone between power levels 1 and 9, using the plus
(2) and minus (3) buttons. By holding down either of these
buttons, the value on the zone indicator (5) will adjust up or
down.
o The central section of the dual cooking zone will switch on.
cooking zone indicator (5) will show a flashing
letter "H". This means that the temperature of the
zone is over 60°C and is therefore still high enough
to cause injury.
WHEN
THE
o Press the cooking zone plus button (2) for the
dual circuit zone.
TEMPERATURE
OF
IT
HAS
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bhc635ss-aus

Table of Contents