Using Optional Equipment; Deactivating The Buttons On The Unit (Child Lock); Setting The Automatic Standby Function - Sony SHAKE-100D Operating Instructions Manual

To check the timer setting or
activate the timer again
1
Hold down SHIFT, then press
TIMER MENU.
"TIMER SELECT" flashes in the
display panel.
2
Press
3
Press
"PLAY SELECT" or "REC
SELECT", then press
To cancel the timer
Repeat the same procedure as above and
select "TIMER OFF" in step 3, then press
.
Notes
• The system turns on before the preset time. If
the system is turned on at the preset time or if
"STANDBY" flashes in the display panel, the
Play Timer and the Recording Timer will not
play or transfer.
• Do not operate the system from the time the
system turns on until the playback or transfer
starts.
Using optional
equipment
1
Press VOL – repeatedly until
"VOLUME MIN" appears in the
display panel.
2
Connect an optional equipment
(page 18).
3
Press FUNCTION repeatedly to
select the function which
corresponds to the connected
equipment.
4
Start playing the connected
equipment.
5
Press VOL + repeatedly to adjust
the volume.
50 GB
.
/ repeatedly to select
.
Deactivating the
buttons on the unit
(Child Lock)
You can deactivate the buttons on the unit
(except "/1) to prevent misoperation,
such as child mischief.
Hold down x on the unit for more
than 5 seconds.
"CHILD LOCK" and "ON" appear in the
display panel.
You can only operate the system using the
buttons on the remote control.
To cancel, hold down x on the unit for
more than 5 seconds until "CHILD
LOCK" and "OFF" appear in the display
panel.
Note
Child Lock function will be canceled when you
disconnect the power cord.
Setting the automatic
standby function
This system is equipped with an
automatic standby function. With this
function, the system enters standby mode
automatically in about 15 minutes when
there is no operation or audio signal
output.
By default, the automatic standby
function is turned on.
1
Hold down SHIFT, then press
OPTIONS.
2
Press / repeatedly to select
"AUTO STANDBY", then press
.
3
Press / repeatedly to select
"ON" or "OFF".
To exit the options menu, hold down
SHIFT, then press OPTIONS.