Precautions - Sony SHAKE-100D Operating Instructions Manual

PROTECTED
The USB device is write-protected.
PUSH STOP
You tried to perform an operation that can
be performed only when the playback is
stopped.
READING
The system is reading information of the
disc or USB device. Some operations are
not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
STEP FULL
You tried to program more than 25 steps.
TRACK FULL
You cannot transfer onto the USB device
because the number of file has reached its
maximum.

Precautions

When carrying the unit
Perform the following procedure to
protect the disc mechanism.
Use the buttons on the unit to perform this
operation.
1
Press "/1 to turn on the system.
2
Press DVD/CD.
3
Remove the disc.
Press Z OPEN/CLOSE to open and
close the disc tray.
Wait until "NO DISC" appears in the
display panel.
4
Unplug the power cord.
Notes on discs
• Before playing, wipe the disc with a cleaning
cloth from the center outward to the edge.
• Do not clean discs with solvents, such as
benzine, thinner, or commercially available
cleaners or anti-static spray intended for vinyl
LPs.
• Do not expose discs to direct sunlight or heat
sources such as hot air ducts, nor leave it in a
car parked in direct sunlight.
On safety
• Completely disconnect the power cord (mains
lead) from the wall outlet (mains) if it is not
going to be used for an extended period of
time. When unplugging the unit, always grip
the plug. Never pull the cord itself.
• Should any solid object or liquid get into the
system, unplug the system, and have it
checked by qualified personnel before
operating it again.
• AC power cord must be changed only at the
qualified service shop.
On placement
• Do not place the system in an inclined
position or in locations that are extremely hot,
cold, dusty, dirty, or humid or lacking
adequate ventilation, or subject to vibration,
direct sunlight or a bright light.
• Be careful when placing the unit or speakers
on surfaces that have been specially treated
(for example, wax, oil, polish) as staining or
discoloration of the surface may result.
• If the system is brought directly from a cold to
a warm location or is placed in a very damp
room, moisture may condense on the lens
inside the unit, and cause the system to
malfunction. In this situation, remove the
disc, and leave the system turned on for about
an hour until the moisture evaporates.
On heat buildup
• Heat buildup on the unit during operation is
normal and is not a cause for alarm.
• Do not touch the cabinet if it has been used
continuously at a high volume because the
cabinet may have become hot.
• Do not obstruct the ventilation holes.
On the speaker system
This speaker system is not magnetically
shielded, and the picture on nearby TV sets may
become magnetically distorted. In this situation,
turn off the TV, wait 15 to 30 minutes, and turn
it back on. If there is no improvement, move the
speakers far away from the TV.
59 GB