Additional Information; Troubleshooting - Sony SHAKE-100D Operating Instructions Manual

Notes
• The message "AUTO STANDBY" flashes in
the display about 2 minutes before entering
standby mode.
• The automatic standby function does not work
during tuner function.
• The system may not enter standby mode
automatically in the following cases:
– when an audio signal is detected.
– during playback of audio files.
– while the preset Play Timer, Recording
Timer or Sleep Timer is in process.
– when microphone is connected.

Additional Information

Troubleshooting

Should you encounter a problem with
your system, find your problem in the
troubleshooting checklist below and take
the corrective action.
If the problem persists, consult your
nearest Sony dealer.
Note that if the service personnel changes
some parts during repair, these parts may
be retained.
If "PROTECT EXX" (X is a number)
appears in the display panel
Immediately unplug the power cord,
and check the following items.
• Are you using only the supplied
speakers?
• Is anything blocking the ventilation
holes of the unit?
After checking the above items and
fixing any problems, plug in the power
cord again and turn on the system. If
the issue persists, consult your nearest
Sony dealer.
General
The system has entered standby
mode.
• This is not a malfunction. The system
enters standby mode automatically in
about 15 minutes when there is no
operation or audio signal output
(page 50).
The clock or timer setting is canceled.
• The power cord is disconnected or a
power failure occurred. Set the clock
(page 21) and timer (page 49) again.
There is no sound.
• Adjust the volume.
• Check the speaker connections
(page 17).
51 GB